I have two different routers that MUST have the exact same hash, so the only way I found to acomplish that is to configure the same loopback interface in both routers. Is there a way to set the ARM Router IDs without configuring loopbacks interfaces? Or is there a way to ignore the router-ids from the hash calculation?
The problem is that in order to have the same router-id I have to restart the routers, and then I have to exclude the loopbacks from the IGP and LDP. Also, the configuration looks like a workaround... :-)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...