Hi, I recently purchased the RV180 router and right now it acts as the NAT gateway of my network.
My questions is, what is the proper way to assign let's say 5 public IP address to 5 machines inside LAN?
The router has LAN IP of 192.168.1.1 and public IP say 184.108.40.206-125
LAN computers have IP range 192.168.1.x
My approach was to have one-to-one NAT, mapping 220.127.116.11 to 192.168.1.32
and 18.104.22.168 to 192.168.1.33 and so on
It works so far but the problem is that if I try to access those public IP from inside LAN, they all point to the router, and I can't find any tool to redirect traffice unless modifying host file on each computer. So I guess there's better way to do this?
I have about 50 domain names pointing to those public IPs. So I will have to set up an internal DNS server and every time there's a dns change, I'll have to update both internal and public DNS servers?
and the reason I have to use public domain is for example apache virtual host, it reads domain name
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.