Hi, sorry to be a newbie but I have an ASA 5525 (actually two but leave that aside for now) which I would like to front a redundant network with two Netgear M7100 switches.
All my servers are connected to both switches using bridged interfaces. The switches are cross connected. As such this will survive the loss of either switch.
What I want to know is how to do the same bridging on the ASA 5525. All I need to know for now is what protocol would allow this to work. I can read the documentation from there and this kit is not in production so I can experiment.
Iam not sure of any bridging protocols but as you have 2 units, you can go with Active/standby or Active/Active failover configurations (based on your requirements). Please check the below links for more information.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.