Re: Astro Errors - CAT 4006 - Is this a possible SUP III module
Try powering the switch all the way down . Earlier versions of this switch had sdram problems sometimes asic timeout would occur , later versions of code actually had a built in test that runs in the background that tests this and if it see a problem it isolates the problem areas and reloads itself . If this happens it should be replaced anyway but the switch will continue to work until you get a replacement . This also could be caused by a faulty or infected station on the switch using up all the bandwidth causing the supervisor to be unable to talk to the linecards . You could try pulling one linecard at a time to eliminate that possibility or disable one module at a time from the command line just don't hang yourself out by disabling the card that feeds the uplink .
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.