Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Async Line Configuration

Hi

i am working with 1841 with WIC-2A/s . created Async lines. when i try to telnet to Async lines its connecting. i am able to communicate for very short period after some time communication is going down if i type alphabets of 26 i am able to get only 10 out of it here i am attaching the configuration. plz tell me how to resolve this error.

Hyper terminal side : 9600/8/1/non/Hardware flow control

remote telnet : 192.168.1.202 2018

2 REPLIES

Re: Async Line Configuration

HI,

Hope this Link will help you to Solve.

http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1831/products_command_reference_chapter09186a0080087e18.html#1018303

INFO: Cisco IOS support multi-protocol packet assembler/disassembler (PAD)

services to allow asynchronous terminals to connect to hosts via the X.25 protocol.

PAD services are enabled by default on cisco routers. Disable the service unless

absolutely needed.

PLS Rate if HELPS

Best Regards,

Guru Prasad R

New Member

Re: Async Line Configuration

no this is not the solutions. what i am looking

thank you for your advise

Javahar

279
Views
0
Helpful
2
Replies