Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATM INTERFACE BANDWIDTH UTILISATION

please i have atm interfaces between two locations carrying STM-1 LINK,HOW DO I CALCULATE BANDWITH UTILISATION IN PERCENTAGE,attached is snapshot of show int atm 2/0 taken every 1hr

1 REPLY
Silver

Re: ATM INTERFACE BANDWIDTH UTILISATION

If you want to know how much traffic is sent over a specific interface at a moment in time, you have several ways. The first one is to set the 'load-interval' under the interface to 30s (load-interval 30) and check the 'output rate' counter under show interface. This only shows a 30s average but it gives you an idea of the current interface utilization. Another way to do this would be to take snapshots of the 'output byte' counters under show interface at regular intervals and make output rate averages across those intervals. This could be done manually or through the use of proper SNMP get commands. Some management software could be be used such as MRTG.

For more information, you could have a look to the following URL:

http://www.cisco.com/warp/customer/121/pvc_utiliz.html

260
Views
0
Helpful
1
Replies