Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATM link configration

Hello ,,

I have 7200 VXR router and I need to configure on it ATM connection , it's my first time to configure an ATM ,so can you people help me i have some questions lik what information do I need to get from the data provider ?? and what is the syntax of the configuration

many thanks

1 REPLY
New Member

Re: ATM link configration

You'll need to know things like the VPI/VCI addressing, whether the circuit is VBR, UBR, etc., encapsulation, etc. If your provider is competent, they should be able to provide you with a template for a Cisco router to get you started.

I'm sure you're looking for the "one size fits all" ATM interface configuration, but it isn't that simple. It all depends on what you really bought how the circuit will end up being used. Just IP data traffic? Carved up into multiple priorities, with some for voice, some for data, etc.? Is it a point-to-point ATM, or point-to-cloud? Will you be mapping frame-relay into the ATM (FRASI)? Will you be muxing multiple T1's into a single logical ATM (IMA)? Not as simple as frame or PPP, unfortunately. That's not to say it's HARD, just that you'll need to work closely with your provider to make it work properly. And again, I'd have every expectation that your provider can support you with an engineer that can get you going.

This link has lots of good ATM info for the 7200, including configuration examples.

http://www.cisco.com/en/US/customer/products/hw/modules/ps2033/products_implementation_design_guide_chapter09186a008019994d.html

HTH!

129
Views
0
Helpful
1
Replies
CreatePlease to create content