Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

authentication mac-move permit

Hi,

 

I want to question in relation to the command "authentication mac-move permit".

 

This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches?

(used Wired 802.1x.)

 

When not authenticated to move the terminal to other switches, it went well You can use this command.

 

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions

Hey,Regarding your question

Hey,

Regarding your question:

This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches? - You are correct, mac move is allowed only on a single switch.

HTH.

Regards,

RS.

 

2 REPLIES

Hey,Regarding your question

Hey,

Regarding your question:

This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches? - You are correct, mac move is allowed only on a single switch.

HTH.

Regards,

RS.

 

Community Member

Hi,rajeevsh thank you. It's

Hi,rajeevsh

 

thank you.

 

It's does not lead to another reason is likely.

(hmmm)

I will investigate again.

 

Regards,

1400
Views
0
Helpful
2
Replies
CreatePlease to create content