Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Auto MDI Issue

I have one 4506E with sup card cp-wx45-sup6l-e and line card wx4648e running IOS version 12.2 (53) sg2. Other end is connected to 2950, IOS 2.1`(22).

Auto MDI is enabled on line card wx4648e with auto duplex & speed on. But operational status of the port is going down when I am connecting with a straight cable. With crossover cable it is working fine.

Waiting for urgent reply.

Thanks & Regards

3 REPLIES

Re: Auto MDI Issue

I have one 4506E with sup card cp-wx45-sup6l-e and line card wx4648e running IOS version 12.2 (53) sg2. Other end is connected to 2950, IOS 2.1`(22).

Auto MDI is enabled on line card wx4648e with auto duplex & speed on. But operational status of the port is going down when I am connecting with a straight cable. With crossover cable it is working fine.

Waiting for urgent reply.

Thanks & Regards

Hi,

Cisco 2950  don't support auto-mdi/mdix, so i would suggest to begin with  the correct cable.

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

Community Member

Re: Auto MDI Issue

Hi Ganesh,

This is not the actual issue.

Actual issue is POE line cards does not work with auto mdi enabled. So, we have disabled power-line in interface config mode to get the issue resolved.

Thanks & Regards

Hall of Fame Super Blue

Re: Auto MDI Issue

with auto duplex & speed on

Hold on.  What do you mean by "speed on"?  Auto MDI/MDI-X works if speed and duplex are set to AUTO.  If either one is hard-coded then auto-mdix is disabled.

548
Views
0
Helpful
3
Replies
CreatePlease to create content