Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Auto QOS error message Cisco 3825 router with HWIC-D-9ESW

On a Cisco 3825 router with HWIC-D-9ESW

Receive the following error message after command auto qos voip trust

Router(config)#interface FastEthernet0/1/0

Router(config-if)#auto qos voip trust

%Error: FastEthernet0/1/0 Service Policy Configuration Failed.Only IN Direction Supported

I am using the following IOS

c3825-ipvoice_ivs-mz.124-11.XJ1.bin

2 REPLIES
Silver

Re: Auto QOS error message Cisco 3825 router with HWIC-D-9ESW

Can you verify that you are not applying auto-qos on a multilink and verify that you have mls-qos enable, make sure on your etherswitch card you don't have any trunk configuration.

Community Member

Re: Auto QOS error message Cisco 3825 router with HWIC-D-9ESW

I am not applying auto-qos on a multilink.

I do not have any trunk configuration on my etherswitch card.

As to do I have mls-qos enable.

I believe I do.

However I do not find a command to enable mls-qos

Still receiving following error

Router(config)#interface FastEthernet0/1/0

Router(config-if)#auto qos voip trust

%Error: FastEthernet0/1/0 Service Policy Configuration Failed.Only IN Direction Supported

AutoQoS Error: the following command was not properly applied:

service-policy output AutoQoS-Policy-Trust

I have attached the entire config

730
Views
0
Helpful
2
Replies
CreatePlease to create content