Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Auto qos error

Hi,

I have an access switch C4506. When I try to use "auto qos voip trust" o "auto qos voi cisco-phone" I have the following error:

C4506E-CIBII-MUSEO-4(config-if)#auto qos voip trust

The policy AutoQos-VoIP-Input-Cos-Policy cannot be attached to the interface Gi1/3 since it has 'set' actions. IP Routing and CEF Switching are required for 'set' actions to be effective.Please enable IP routing and CEF switching.

AutoQoS Error: the following generated command was not properly applied:

service-policy input AutoQos-VoIP-Input-Cos-Policy

no service-policy attached to this interface

no service-policy attached to this interface

Class-map AutoQos-VoIP-Bearer-Cos is being used

Class-map AutoQos-VoIP-Control-Cos is being used

Class-map AutoQos-VoIP-Bearer-Dscp is being used

Class-map AutoQos-VoIP-Control-Dscp26 is being used

Class-map AutoQos-VoIP-Control-Dscp24 is being used

Class-map AutoQos-VoIP-Bearer-QosGroup is being used

Class-map AutoQos-VoIP-Control-QosGroup26 is being used

Class-map AutoQos-VoIP-Control-QosGroup24 is being used

AutoQoS Error while generating commands on Gi1/3.

The IOS version is:

Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-LANBASE-M), Version 12.2(53)SG2, RELEASE SOFTWARE (fc1)

I have tried to find some information in the Software Bug ToolKit but I failed.

Any idea?

Thanks in advanced

Everyone's tags (3)
2 REPLIES

Auto qos error

Do you have CEF and routing enabled on the switch?

Please enable IP routing and CEF switching.

HTH, John *** Please rate all useful posts ***
New Member

Auto qos error

No, I don't have routing and CEF enabled on the switch.

Why do I have to enable IP routing in a access device?

920
Views
0
Helpful
2
Replies
CreatePlease to create content