Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Auto QOS on 6500 line cards?

In the documentation "Quality of Service on Cisco Catalyst 6500", it talks about auto-qos and that it is applied in two steps. Firat at the system level, and then at the port level.

However on my 6509/Sup720 (2.12(18)SXF5) with 48-port 6548-TX line cards I cannot find any 'auto qos' commands either at the global level or at the interface level.

If the 6500 does indeed do auto qos, where do I find the commands?

1 REPLY
New Member

Re: Auto QOS on 6500 line cards?

Supported in CatOS only

159
Views
0
Helpful
1
Replies