cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
291
Views
0
Helpful
1
Replies

Auto QOS on 6500 line cards?

jkeeffe
Level 2
Level 2

In the documentation "Quality of Service on Cisco Catalyst 6500", it talks about auto-qos and that it is applied in two steps. Firat at the system level, and then at the port level.

However on my 6509/Sup720 (2.12(18)SXF5) with 48-port 6548-TX line cards I cannot find any 'auto qos' commands either at the global level or at the interface level.

If the 6500 does indeed do auto qos, where do I find the commands?

1 Reply 1

situwayne
Level 1
Level 1

Supported in CatOS only

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: