Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

auto qos voip trust within channel-group

Hello I need to know if I can to set the auto qos voip trust within of:

interface GigabitEthernet2/1

no switchport

no ip address

channel-group 2 mode active

spanning-tree portfast

end

CEM_PB_SW_CORE#conf t

Enter configuration commands, one per line. End with CNTL/Z.

CEM_PB_SW_CORE(config)#interface GigabitEthernet2/1

CEM_PB_SW_CORE(config-if)#auto qos vo

CEM_PB_SW_CORE(config-if)#auto qos voip tr

CEM_PB_SW_CORE(config-if)#auto qos voip trust

AutoQoS Error: AutoQoS can not be configured on member port(s) of a port-channe

1 REPLY
Purple

Re: auto qos voip trust within channel-group

It probably has to go on the port channel interface and not the ports themselves .

int port-channel 2

auto qos voip trust

383
Views
0
Helpful
1
Replies