Auto Smartports configuration for non cisco devices
I am looking at implementing auto smartports but for non cisco devices i.e printers, computers and building services equipment that connects to the network. Is there anyway to do this besides creating mac address groups and assigning the oui to these as this would cause quite a bit of overhead due to the number of switches and different VLANs we have for each building. We also have quite a few different brands of printers and devices so I was wondering if there was any other way for the ports to 'auto detect' these devices?
I’m hoping there is a way to simplify this so if anyone has any ideas that would be greatly appreciated!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.