Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

auto upgrade path ... how to set them

on show boot-command i found an entry called "auto upgrade path". what stand it for?

Switch#sh boot

BOOT path-list      : flash:/ies-lanbase-mz.122-55.SE5/ies-lanbase-mz.122-55.SE5.bin

Config file         : flash:/config.text

Private Config file : flash:/private-config.text

Enable Break        : yes

Manual Boot         : no

HELPER path-list    :

Auto upgrade        : yes

Auto upgrade path   :

NVRAM/Config file

      buffer size:   65536

Timeout for Config

          Download:    0 seconds

Config Download

       via DHCP:       disabled (next boot: disabled)

i would like to bring a new IOS-image to this switch while auto-setup-procedure. Auto upgrade is already set to yes.

Does anybody know how to use this feature?

EEM does not work correct because it's limited by ies-lanbase-version of IOS.

thanks for good ideas

Heiko

Everyone's tags (5)
232
Views
0
Helpful
0
Replies
CreatePlease to create content