Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AUTOQOS cisco-phone interrogation

Hi All,

I have now to look at QoS, I find switch already configured with Cisco-Pohne auto QoS configured.

currently the following command are configured on the interface configuration :

Interface fa0/1

sw acc vl 1

switchport mode acces

switchport nonego

switchport voice vlan 2

srr-queue bandwith share 10 10 60 20

priority-queue out

mls qos trust device cisco-phone

mls qos trust cos

auto qos voip cisco-phone

spanning-tree portfast

service-policy input AutoQoS-Police-CiscoPhone


but when I issue the command:

show mls qos int fa0/1 queue (on the same switch)

I got the following output information :

Egress Priority Queue : enable

Shape queue weights (absolute) : 25 0 0 0

Shared queue weight : 10 10 60 20

The port badnwith limit : 100 (operationnal bandwith :100.0)

The port is mapped to qset : 1

I red Shape queue override shared queue configuration on the same interface, I understood here the queue 1 has 25% of bandwith reserved and limit to.  Queue 2 to 4 has no Shape queue configuration so the 75% on the bandwith remain on that interface would be divised between the remain queue.

I the configuration, I did not find any interface command which configured shapping default configuration for all interfaces on the switch.  But I like to understand from where they shapping configuration of the queue 1 is comming from ? their is any default configuration (which is not shown) which can explain this behavior !

I just would like to understand, I'm not very happy to have configured some stuff which I can't explain behavior after fact, when comming time to support them after it would be great to understand those properly.

Thanks everybody !

Everyone's tags (3)
4 REPLIES
Silver

AUTOQOS cisco-phone interrogation

hi Xine,

is your switch configured with auto Qos ?

thanks

New Member

AUTOQOS cisco-phone interrogation

Hi !

yes it is like specified in the switch port fa0/1 configuration !

"auto qos voip cisco-phone" macro command under the interface fa0/1.

or maybe I misunderstood your question !

Silver

AUTOQOS cisco-phone interrogation

HI ,

look like it the default Behavior of Auto Qos and it reserve some bandwidth for egress queue.

Just checked in my 2960 and its same.

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_53_se/command/reference/cli2.html#wp1947019

http://networkenhancers.blogspot.co.nz/2011/05/in-previous-versions-of-qos-2.html

hope this helps.

thanks

Silver

AUTOQOS cisco-phone interrogation

hi,

check this link its really good and  hopefuly will ans your all questions.

https://supportforums.cisco.com/docs/DOC-8093

please rate if this helps.

thanks

345
Views
5
Helpful
4
Replies
CreatePlease login to create content