Can I deploy AutoQOS on my LAN switching and layer 3 switching when using a Siemens VOIP solution. I realise that their phones do not do CDP, so I need to trust the COS on the access port. But can I use all the other AutoQOS settings?
Assuming the phones mark the voice packets to the same markings as the cisco phones do (usually EF), and the signalling traffic to the same as the cisco phones (CS3 i think), and the trust boundary is moved to trust the phones, then you should be good to go.
You just have to make sure that the PC that is connected to that port (if the PC connects to the phone, and the phone to the switch for example) has its packets marked to zero as appropriate. You don't want a situation where some smart user's mark their PC's traffic as EF, and your switch trusts it..
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...