Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

backplance utilization on cat4500

Is it possible to monitor the backplane utilization of a catalyst 4500 switch?

SupV-10GE

I only know the Utilization LEDs on the Supervisor.

Robert

2 REPLIES
Bronze

Re: backplance utilization on cat4500

You may try using the “show environment” CLI command to monitor the system and to find the power consumed by the backplane in Supervisor Engines II-Plus to V-10GE.

Command: show environment [alarm | status | temperature]

Temperature - Displays temperature of the chassis

Purple

Re: backplance utilization on cat4500

bwilmoth is correct "show environment" will show you switch bandwidth utilization . Don't ask me why they stuck it under the show environment command , thats not intuitive at all.

153
Views
0
Helpful
2
Replies