Hi all, I need to monitor the utilisation of my internet routers, I do not have access to them, nor does my symantec firewall provide this info, we have a switch for the internet (public network), is it possible to monitor the bandwidth of a port without putting any ip addresses on the switch? or should I put the switch on a private address range so noone can get to it from outside and monitor it using snmp ?
Get a Lap top and install the wireshark protocol analyzer or another kind of protocol analyzer then configure the span feature in your switch then start to monitor your network, this configuration does not require and ip address configured in the switch
Also you can configure the switch with a private ip address, configure the SNMP parameter in the switch and then connect your SNMP server and monitor your network
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.