Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bandwidth & Police Statement

I want apply an inbound police policy on a WAN interface, I have all the traffic classes defined with the following statement "police cir percent," however what if I want to police the default traffic (traffic that is not matched by class map), what would the following do? Will this limit inbound best effort traffic to minimum of 25% and maximum of 50%?

class class-default
    bandwidth percent 25
    police cir percent 50


Best regards,

Jaffer

1 REPLY
VIP Super Bronze

Re: Bandwidth & Police Statement

Hi Jaffer,

It should work. I tested it on 2800 and can see that "sh policy-map test" shows that the default traffic at 25 and 50.

policy-map test
class test
  priority 6144 3072
class class-default
  bandwidth percent 25
  police cir percent 50

T-1#sh policy-map test
  Policy Map test
    Class test
      Strict Priority
      Bandwidth 6144 (kbps) Burst 3072 (Bytes)
    Class class-default
      Bandwidth 25 (%) Max Threshold 64 (packets)
     police cir percent 50
       conform-action transmit
       exceed-action drop
T-1#

HTH

Reza

461
Views
0
Helpful
1
Replies