Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bandwidth - RateLimit command

Hi All, Are the commands different for restricting bandwidth on Switch interface for Cisco2960 and cisco3560.

Wanna limit interface fa0/9 to 2MB

4 REPLIES
New Member

Re: Bandwidth - RateLimit command

Hi Saquib. You could use a policy map to do this.

ip access-list extended ALL_TRAFFIC

permit ip any any

!

class-map match-all ALL_IP

match access-group name ALL_TRAFFIC

!

policy-map 2MB_LIMIT

class ALL_IP

police 2000000 50000 exceed-action drop

!

interface FastEthernet0/9

service-policy input 2MB_LIMIT

Thanks

Dan.

New Member

Re: Bandwidth - RateLimit command

what does 50000 refers in command " police 2000000 50000 exceed-action drop

!

"

Looking similar with Rate-Limit for Cisco 2960 Switch

New Member

Re: Bandwidth - RateLimit command

Its the burst value.

228
Views
0
Helpful
4
Replies