Objective: Limit incoming and outgoing bandwidth for each user (switch port) when accessing external (Internet) resources while at the same time allowing access to internal resources (servers, printers, etc.) at unthrottled speeds.
I have found configurations that work using policy maps / QoS that will allow me to throttle on a per switchport basis. I am having a problem figuring out where to change the configuration to allow the full access to internal resources. I have attempted to create a access-list with the necessary internal ip address and added them to a class-map. I then added the class-map to the policy-map but last time I tried it disabled all throttling. I don't know if it is the implicit deny all the end of the access-list or if I'm even placing it in the right order on the policy-map. Actually I'm literally learning policy-map/class-maps as I do this.
If there is a simpler way to achieve this, im all ears. Also is there a way to include the whole internal 192.168.1.0 network while still throttling things going to the gateway address?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.