04-07-2007 12:50 PM - edited 03-05-2019 03:21 PM
I have a 4700 router with fast ethernet subinterfaces. I'd like to be able to view bandwidth used on these interfaces (5min input rate, 5min output rate). Currently the output for the subinterfaces does not show this. Is it possible to display this as well?
Thanks
Raja
04-07-2007 06:35 PM
Since you have Fast Ethernet subinterfaces then I would assume that you are running Trunking on your FE interface. If you are then the bandwidth usage will reside on the physical interface. So if you have FE0/1.1 and FE0/1.2, the bandwidth will be calculated on FE0/1.
04-09-2007 08:42 AM
That is correct, the bandwidth is shown on the trunk. However I need the bandwidth on each subinterface.
I can do this with mrtg/snmp. However I wanted to see if there was any way to display it from the console.
Raja
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide