Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

banner problem catalyst 6509e

hi,

i trie to put in a banner on a catalyst 6509e. there is no error message at all. the banner i trie to put in works on other switches without problems.

but when i look at the config the banner entry is empty:

!
banner exec ^C
^C
banner login ^C
^C
!

the only that is different to all other switches is that this switch is in a VSS bundle.

(s72033_rp-IPSERVICESK9_WAN-VM), Version 12.2(33)SXI, RELEASE SOFTWARE (fc2)

any ideas, bug or ???, regards Reinhold.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: banner problem catalyst 6509e

Hello Reinhold,

there are bugs like

CSCei52830            Bug Details

Banner command sync is broken by CSCin86483
Symptoms: The banner motd command may not properly function when you enter a
message-of-the-day (MOTD) through the banner motd
d message d command because the d message
d
argument of the command may not be synchronized to the standby RP.

Conditions: This symptom is observed on Cisco router or switch that is
configured for SSO.

CSCsv54929            Bug Details

Cannot save banner bigger than 2048 characters

Symptom:
Banner bigger than 2048 chracters does not show up in show run after
a reload. "sh run" or "wr mem" reports traceback error.

or the following one:

CSCsu57889            Bug Details

banner exec CLI ignoring lines starting with #, !, and ;
Symptoms:

Banner lines starting with "#", "!", or ";" characters are not stored in the running configuration.

Conditions:

No specific conditions.

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: banner problem catalyst 6509e

Hello Reinhold,

there are bugs like

CSCei52830            Bug Details

Banner command sync is broken by CSCin86483
Symptoms: The banner motd command may not properly function when you enter a
message-of-the-day (MOTD) through the banner motd
d message d command because the d message
d
argument of the command may not be synchronized to the standby RP.

Conditions: This symptom is observed on Cisco router or switch that is
configured for SSO.

CSCsv54929            Bug Details

Cannot save banner bigger than 2048 characters

Symptom:
Banner bigger than 2048 chracters does not show up in show run after
a reload. "sh run" or "wr mem" reports traceback error.

or the following one:

CSCsu57889            Bug Details

banner exec CLI ignoring lines starting with #, !, and ;
Symptoms:

Banner lines starting with "#", "!", or ";" characters are not stored in the running configuration.

Conditions:

No specific conditions.

Hope to help

Giuseppe

New Member

Re: banner problem catalyst 6509e

hi giuslar,

thanks for the quick answer. your answer was the solution. my text started with #. i changed this in $.

thanks again, regards Reinhold.

831
Views
5
Helpful
2
Replies
CreatePlease to create content