Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Banwidth limiting using QOS

Is it possible to limit the bandwidth in different VLAn's using QOS..

i have 5MBPS internet connection ,with 254 public IP I did subnetting for this pool made separate vlan for each public subnet i have to share this connection in different VLAn's, ie is for different clients.. using one cisco 4506 switch.. For eg... for one client 256 kbps, the other one for 512 kbps..

6 REPLIES

Re: Banwidth limiting using QOS

Hi,

You can configure Policing or Shaping whatever method you want to use at the SVI (The Vlan Interface itself) and limit ur bandwidth accordingly.

Regards,

Mohamed Sobair

New Member

Re: Banwidth limiting using QOS

Hi

Can u Give some example for that

Regards

Jaimon

Re: Banwidth limiting using QOS

Hi,

here is a (Policing) example, assumed u are limiting the bandwidth at vlan 10 interface to 256Kbps:-

class-map match-any vlan10

match access-group 100

access-list 100 permit ip any any

policy-map vlan10 (Rate limited at 256Kbps)

class vlan10

police 256000000 32000 action transmit exceed action drop

int vlan 10

service-policy output vlan10

HTH

Mohamed Sobair

New Member

Re: Banwidth limiting using QOS

Is the police command correct? Should it not be:

police 256000 32000 action transmit exceed action drop

Re: Banwidth limiting using QOS

Yes , you are right...

I think I have misatkenly typed it with extra 3 Zeros. Hence it in Bps , so it should be 256000.

Regards,

Mohamed Sobair

New Member

Re: Banwidth limiting using QOS

Thank u .Its Working

197
Views
5
Helpful
6
Replies
CreatePlease to create content