Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Basic Question - Setting an interface to default values

Is there a command to set an interface back to default values? Rather than go through a series of no commands?

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Basic Question - Setting an interface to default values

Hi,

Router(config)# default interface Serial0

should do the trick.

Hope this helps! Please use the rating system.

Regards, Martin

2 REPLIES
Cisco Employee

Re: Basic Question - Setting an interface to default values

Hi,

Router(config)# default interface Serial0

should do the trick.

Hope this helps! Please use the rating system.

Regards, Martin

Community Member

Re: Basic Question - Setting an interface to default values

Thanks,

knew it would be simple - just couldn't find it

136
Views
0
Helpful
2
Replies
CreatePlease to create content