Basic switch configuration

[ealvesibm]

Hey Guys

Im starting to study for Cisco and I have a doubt about a simple configuration.

I have 2 PCs connected to a switch ok, with both PCs configured with the following configuration as follow :

PC1 as 192.168.1.2 and PC2 as 192.168.1.3

When I run a ping command via pc1 to pc2 , the connection doesnt work.

In this case, do I have to configure the switch also, or there is no need for that ???

Where is the fault ??

[cadet alain]

Hi,

Try disabling firewall on PC2. if it still won't work post the config of the switch to see if the 2 ports are in the same vlan.

Regards.

Alain

[ealvesibm]

issue resolved.

tks

[cadet alain · Accepted solution]

Hi,

Could you mark the thread as solved and rate helpful posts.

Regards.

Alain