Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Basic switch configuration

Hey Guys

Im starting to study for Cisco and I have a doubt about a simple configuration.

I have 2 PCs connected to a switch ok, with both PCs configured with the following configuration as follow :

PC1 as 192.168.1.2 and PC2 as 192.168.1.3

When I run a ping command via pc1 to pc2 , the connection doesnt work.

In this case, do I have to configure the switch also, or there is no need for that ???

Where is the fault ??

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Basic switch configuration

Hi,

Could you mark the thread as solved and rate helpful posts.

Regards.

Alain

Don't forget to rate helpful posts.
3 REPLIES
Purple

Basic switch configuration

Hi,

Try disabling firewall on PC2. if it still won't work post the config of the switch to see if the 2 ports are in the same vlan.

Regards.

Alain

Don't forget to rate helpful posts.
New Member

Basic switch configuration

issue resolved.

tks

Purple

Basic switch configuration

Hi,

Could you mark the thread as solved and rate helpful posts.

Regards.

Alain

Don't forget to rate helpful posts.
204
Views
0
Helpful
3
Replies