I have a BCM50 with IP sets. I am trying to get an IP set to work from a remote location. I have set up NAT in my 2901 router to forward the public ip to the ip of my BCM. My set has a private ip from my remote dsl and I have set my S1 to be the public IP that is being forwarded. The set wants to come up. Meaning I have my system message and it asked for my registration password. Right now it is just cycling over and over. From what I can tell Nortel wants Cone NAT. I cannot find any examples of how to config this. Can someone give me a hand or point me to a link?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...