Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

BCMSN - VoIP Trunk - Switching

I am studying for the BCMSN and have a question about VoIP and trunking.

I see that when you have an Access port you should add lines:

mls qos trust device cisco-phone

mls qos trust cos

auto qos voip cisco-phone

Do I need to add anything of these to the trunk port?

Should I add anything else to the trunk?

Also, if there was a point-to-point with routers, would the trunks need anything else special to allow QoS to function properly?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: BCMSN - VoIP Trunk - Switching

Hi,

auto qos voip cisco-phone command enables the other two commands :

mls qos trust device cisco-phone---- the interface is trusted only when cisco ip phone is dectected via cdp.

mls qos trust cos---once deteced CoS values is trusted.

Ideally yes we trust the trunk ports for the incoming traffic. If you your traffic is local to the switch and does not cross trunk ports you dont need any configuration on the trunk ports.

"auto qos voip trust" is used on trunk links.

Hope that helps.

JayaKrishna

1 REPLY
Cisco Employee

Re: BCMSN - VoIP Trunk - Switching

Hi,

auto qos voip cisco-phone command enables the other two commands :

mls qos trust device cisco-phone---- the interface is trusted only when cisco ip phone is dectected via cdp.

mls qos trust cos---once deteced CoS values is trusted.

Ideally yes we trust the trunk ports for the incoming traffic. If you your traffic is local to the switch and does not cross trunk ports you dont need any configuration on the trunk ports.

"auto qos voip trust" is used on trunk links.

Hope that helps.

JayaKrishna

354
Views
0
Helpful
1
Replies
CreatePlease to create content