Switching

I'm an IT tech for a non profit organization in NYC with around 250 employees. We are moving to a new location next week, so our IT room has to be moved and re assembled at the new location. We have 15 switches, 2 routers and a ASA 5510 firewall. Is ...

There are 2 3760g catalyst stacked using 2 StackWise cables.Then the 2960s are stacked using 4 ports as etherchannels.The switches work fine. Now where I’m having a problem is I want to set up a second etherchannel between the 3760s and the 2960s. I ...

Hi everyone:I have an issue regarding route injection between a vrf interface and a global interface.The configuration is something like this:I need vrf V1 network and 192.168.2.0 network reach each other.I tried straight routes at first but it didn'...

This is to support a user who has the requirement of simulating specific speeds for download/upload.  We have configured a limit using service-policy that as successfully limiting upload speed (ingress on the interface) but we (more importantly) need...

Hi, is there any requirement of setting bandwidth of vlan equal to interfaces(fa or gi? another question) of switch?what will happen if we set vlan bandwidth lower than the interface? Thanks,Visha   

Hi, What are mac address cpu entries? Vlan    Mac Address       Type        Ports—-    ———–       ——–    —–All    0100.0ccc.cccc    STATIC      CPUAll    0100.0ccc.cccd    STATIC      CPUAll    0180.c200.0000    STATIC      CPUAll    0180.c200.0001  ...

HiI am currently installing a new 3650 stack which will service user mitel phones and pcs. In the past, I have used 3560s and 3750s where you need to enable qos globally and on the interface level.My question - is this - it seems that the new 3650 XE...

Hi All,When attempting to load protocol pack on CISCO2951/K9  the following error is encountered. (config)#ip nbar protocol-pack flash:pp-adv-isrg2-153-3.M3-16-12.0.0.pack% NBAR Error: LEXER error : parsing stopped % NBAR Error: Activation failed due...

Hi all, We have a port on our Cisco 4500X switch (VSS) that is experiencing a lot of output drops.  The port experiencing the output drops is the traffic leaving our data center to our headquarters via a 1Gbps Metro-E circuit. We're not experiencing ...

We have a plan to establish IPSec VPN between juniper SRX550 and Cisco routers with OSPF protocol and hub and spoke topology.In hub location we have juniper firewall, spoke locations we have Cisco routers. Please provide me the best deployment method...