Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hi Team,Could someone please let me know why am I seeing the int vlan counter rate as 0??????UK-Switch#sh run int g1/3Building configuration...!interface GigabitEthernet1/3 description uk switchport switchport access vlan 120 switchport mode access  ...

Hi all,I have the following configuration ,ip access-list extended BLOCK deny   ip 46.38.56.0 0.0.7.255 any! class-map match-all BLOCK match access-group name BLOCK!policy-map BLOCK class BLOCK  priority 8  set dscp efpolicy-map QOS!interface f0/0 se...

I have an HP switch and I am attempting to replace the switch with a cisco SG200-50. The HP currently has a VLAN setup for wireless so that the wireless users cannot touch the production network. When I look at the current config of the HP, there are...

Dear All, TIll now I have worked with 2960-X series switches. I am new to 6500 Series switches. As we are upgrading the network. My company is looking for a switch which supports  16 SFP+ ports and 10 Gigabit speed per each Ethernet port.  We are bui...

Hi Guys I have configured 2 4500x switches as a vss pair and vss is working fine. These will be connected to 2 stacks of 3750x switches with each stack having 2 switches.                                 4500x                                /         ...

Hi All,Recently our customer has bought a new supervisor engine 8 for their catalyst 4507R-E chassis to replace the current supervisor engine 6l-e. The problem is when ever the chassis reload with the new supervisor engine 8, it appears a message sta...

I'm reviewing the configurations of a device and I ran across some SNMP config lines that I'm not familiar with, and haven't had much luck googling (I'm admittedly not very familiar with the configuration of SNMP in general).Can someone either give m...

I have a few 65xx and having some issues with getting "snmp traps mac-note change add/remove:on the ports On my switch running IOS v12.2(33) SXH1 / ROM V12.2(17r) SX 3 i can enter the added/removed command on a range of ports no issues. On my swithce...

Hello,I've dug here and else where but have not found a working answer to this. I have two WS-C3750X-24P-S 's both were shipped at the same time, same code.Switch A - in production for a year + with 12.2(55) SE3 code and a upgraded license to ip serv...

mlaporte by Level 1
  • 402 Views
  • 4 replies
  • 0 Helpful votes