I get the following error message: https://pastebin.com/WEwAvbsCThe network is shown in the image. I literally just press start all devices, connect to console and get that. I tried googling the error but nothing shows up.
The VLANIF of the core switch acts as the gateway for client. The Client is unable to obtain the gateway IP, but by manually adding ARP, it can communicate with the gateway. The core switch has the correct MAC and ARP information for the client, a...
hi friendsi config below commands to configure AAA authenticate with Microsoft Active Directory 2008(CIsco Device Integrate with AD microsoft for telnet and ssh and both can login to console by AD and local username) but while i unplugged Cisco Devic...
Subject: Seeking Alternative Network Switch RecommendationHi,I hope you're doing well. We've discovered that the SG110D-08 network switch is no longer available. Could you please recommend an alternative that offers similar features and performance? ...
Hello Community,I am looking a script for switches cisco for block interfaces with APs connected , the reason is because we receive daily port changes and sometimes the engineers change the vlan Wi-Fi by another and the Wi-Fi environment is affected ...
Hi thereI am assigned to check the issues with this attached network and have managed to remove some hups and redesign the network to what it is now. there were no vlans and it has been configured. the issue is that the internet speed is extremely sl...
Does the Catalyst 2960-X or 350-P network switches have internal coin cell batteries to retain memory or clock settings? If so, what is the part number of this battery. Alternatively do you have a safety compliance document for the battery which allo...
I googled this and no answer. What year was it introduced? https://www.ciscopress.com/articles/article.asp?p=2832407&seqNum=5
General question for the community. I'm looking to use a Catalyst 9200 as my internet access switch. Considering bumping my service from 1Gbps to at least 2Gbps and possibly higher. Can the 9200 switch support higher than Gigabit throughput capaci...
Hi,I have a C9200L-48P switch with 4x1G uplink module.Port Gi1/1/1 does not have an LED blinking when connected to another switch.Ports Gi1/1/2-4 seem to work fine.Could anyone please guide me on troubleshooting the port and also advise action?
Hi All,I came across a strange issue today. I have a C9300-48S-A Switch but the show version output of the switch shows that the switch has an Essentials license on it.Below snap for quick ref: Is this an error from Cisco or have I missed something?A...
I wanted to test a local account on a Nexus switch and bypass the radius (ssh)connection. To do so, I add the aaa authentication login default local I am now able to access the local account but I wanna get back to the previous configuration. When...
Hi All - I purchased a CBS220-24t-4G switch a couple weeks back and have been unsuccessful at resolving these two issues. When starting up the switch after the system states Starting Kernel... I receive the following error: "unknown rt error f030". H...
Hi all I'm setting up a CISCO LAB to keep me busy in my retirement. My Current network consists of a TP-Link Deco mesh network which works well for my IOT, PCs and internet access. I just got hold of a Cisco 1941 router with a EHWIC D8SGP module. ...
I have two 9410 switches connected in stackwise , when entering "show version" i can only see the primary stackwise member uptime. How can i see the uptime for the second member?
