Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Best way to separate VLANs in a RoaStick config

Can I get your opinion/pointers on the following scenario? I’m sure both ways work, but which is best?

Corp VLAN 10

Guest VLAN 50

Both have SVI's on 2960 switch, but only for troublshooting/mgt purposes. Gateway IPs are on router.

There is a router on a stick config on 1941 router - g0/0.10 and g0/0.50 and that's where the two networks meet.

What is the best way to block traffic between the two networks? VACL on the switch? ACL on the router?

  • LAN Switching and Routing
1 REPLY

Best way to separate VLANs in a RoaStick config

Hi,

   IMO, ACL on router is easy to modify and troubleshooting.

HTH,

Toshi

350
Views
0
Helpful
1
Replies
This widget could not be displayed.