Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

BFD and OSPF on VLAN interface

Hello,

I'm tryng to enable BFD for OSPF on a SVI on a Catalyst 6509 Sup 720.

Even if the vlan interface accepts the configuration command "ip ospf bfd", no BFD neighborship is established and there is no way to set bfd intervals.

Has anybody encountered the same behaviour?

7 REPLIES
Silver

Re: BFD and OSPF on VLAN interface

Hi,

which version of IOS do you use?

Regards

Andrea

SAP
New Member

Re: BFD and OSPF on VLAN interface

BDF is not supported on SVL

New Member

Re: BFD and OSPF on VLAN interface

Well It's funny, look at this output:

Vlan305 is up, line protocol is up

Internet Address 10.119.200.2/24, Area 0

Process ID 100, Router ID 10.119.253.12, Network Type BROADCAST, Cost: 10

Transmit Delay is 1 sec, State BDR, Priority 1, BFD enabled

Designated Router (ID) 10.119.253.11, Interface address 10.119.200.3

Backup Designated router (ID) 10.119.253.12, Interface address 10.119.200.2

It says that BFD is enabled on the specific VLAN where we configured it but no matter this, no BFD neigborship is established.

Thanks in advance

Fausto

New Member

Re: BFD and OSPF on VLAN interface

Hi Andrea,

we use:

Cisco IOS Software, s72033_rp Software (s72033_rp-IPSERVICESK9-M), Version 12.2(33)SXH1, RELEASE SOFTWARE (fc3)

regards

Fausto

Silver

Re: BFD and OSPF on VLAN interface

Well,

it seems like a problem that I've found some weeks ago on SRB1. The BFD feature was configurable, but not effective. That bug maybe will be corrected on SRC. In your case, I don't know, but my advice is to check the Bug Toolkit, or open a case.

Just for me: SXH modular version?

Regards

Andrea

edit: uops .. I see now ... Have you got a 6500 or a 7600 device?

New Member

Re: BFD and OSPF on VLAN interface

Hi Andrea,

we use mesh made of six 6509 in this hw configuration:

Mod Ports Card Type Model

--- ----- -------------------------------------- ------------------

1 4 CEF720 4 port 10-Gigabit Ethernet WS-X6704-10GE

2 4 CEF720 4 port 10-Gigabit Ethernet WS-X6704-10GE

3 24 CEF720 24 port 1000mb SFP WS-X6724-SFP

4 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX

5 2 Supervisor Engine 720 (Active) WS-SUP720-3B

6 2 Supervisor Engine 720 (Hot) WS-SUP720-3B

7 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX

8 6 Firewall Module WS-SVC-FWM-1

Regards

Fausto

Silver

Re: BFD and OSPF on VLAN interface

Hmm ...

Try to upgrade to SXH2a.

Unfortunately I don't see a specific bug, but maybe is a DDTS bug internal only.

Please let me know

HTH

Regards

Andrea

1469
Views
0
Helpful
7
Replies
CreatePlease to create content