Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

BGP Community

Router#sh route-map

route-map COMMUNITY, permit, sequence 10

Match clauses:

Set clauses:

community 13172786

where this Community comming from?as i Remembere i assigned it such 201:65

2)on the Neighbors when i issue sh ip bgp community 201:65;i didn't find any.how to toubleshoot

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: BGP Community

Ali,

You need to the command ip bgp-community new-format in order to have the community displayed in the format AA:NN.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r/rte_bgh1.htm#wp1074551

HTH,

__

Edison.

4 REPLIES

Re: BGP Community

Hi,

You don't have a "match clauses" and "set clauses" for route-map COMMUNITY. "community 13172786" is a community number

You should have the config...

!

route-map COMMUNITY permit 10

match ip address 101

set community 201:65

!

ip access-list 101 -entries_here-

Can you post your config?

Regards,

Dandy

Community Member

Re: BGP Community

hey Dany

how you Doin?i dont need to match any ip address just i addee the rout-map to the outside neih internal route-map COMMUNITY out

but it didn't work

what now?

Hall of Fame Super Bronze

Re: BGP Community

Ali,

You need to the command ip bgp-community new-format in order to have the community displayed in the format AA:NN.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r/rte_bgh1.htm#wp1074551

HTH,

__

Edison.

Community Member

Re: BGP Community

yes Edisson

i solved it.i forgat to add to the Neight the command:

neigh X send-community

10xs edy

146
Views
5
Helpful
4
Replies
CreatePlease to create content