Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

BGP default route from two provider

Dear all,

I am having two Internet link from two provider and i am taking default route from both the provider

One provider is having cisco router so default in my router showing origin as "incomplete"

while other provider is having juniper router and origin is showing "IGP" in my router

Is there anything by which I at my end change this behaviour and change the path selection criteria so that

forward traffic to internet goes via. both the link.

Thanks & Regards

mahesh

5 REPLIES
Community Member

Re: BGP default route from two provider

Look into route-maps. You can define settings in there.

Re: BGP default route from two provider

Hi Mahesh,

Before evaluating the origin code of a prefix, the BGP path selection process evaluates weight as the first step (in Cisco routers only).

So one solution could be the following:

You can set the weight of the default route on the Cisco router inbound using the "neighbor x.x.x.x weight" command, where x.x.x.x is the BGP router on the ISP side.

This will result in that the Cisco router will route traffic hitting it to its own default route.

The Juniper router also will route traffic hitting it to its own default route (weight is not considered in Juniper routers).

Edit: My supposition here is that both routers learn each other's default route through an iBGP connection.

You will need to configure your IGPs inside your AS to route traffic to the Cisco or Juniper router to do some load sharing between the two edge routers and ISP links respectively.

I also recommend you to test the failover scenarios.

Cheers:

Istvan

Community Member

Re: BGP default route from two provider

I think my problem is not understood

i am having single cisco router which is connected to other cisco router (One provider) and other Juniper router (next provider).

they both announces a default route to me. My requirement is to send traffic via. both the link. Now after doing multipath I can see both the route in BGP table but only one become best from provider who is having juniper router (due to origin as "IGP")

Now if I set weight to one of route only that route will became best and forward traffic goes to one link only.

I need such a thing where both default became best in my routing table

hope this understood

Regards

Community Member

Re: BGP default route from two provider

Now I change the origin and now I am getting both the links routes with equal parameter .

but yet traffic is not going via both the link

HO-ILL-RTR#sh ip bgp 0.0.0.0

BGP routing table entry for 0.0.0.0/0, version 2

Paths: (2 available, best #2, table Default-IP-Routing-Table)

Multipath: eBGP

Flag: 0x820

Not advertised to any peer

1234

125.21.249.113 from 125.21.249.113 (203.101.87.90)

Origin incomplete, metric 100, localpref 100, valid, external

5678

115.113.121.25 from 115.113.121.25 (192.168.196.6)

Origin incomplete, metric 100, localpref 100, valid, external, best

Re: BGP default route from two provider

Hi Mahesh,

I got your point now.

I tested this scenario on routers but it seems to me that BGP does not support multipath for default routes.

However, I did not find any references in Cisco documentation about this.

Cheers:

Istvan

605
Views
5
Helpful
5
Replies
CreatePlease to create content