I have a stack of 3750-x switches, i recently purchsed an IP services license upgrade per switch in the stack so i could run BGP. The license install was successful and it now says the license level is ipservices, however when i try and configure BGP it still says 'protocol not in this image'. Please advise urgently
Re: BGP protocol not in image after license upgrade
thanks for your swift reply. Regardless of the feature set, apparently that IP base version does not support BGP. I installed a Universal-K9 image on there and then rebooted and now everything appears to be fine
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.