Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BGP Query

I have a pair of 6513's each connected to the same ISP via POS. Occasionally I see the attached messages in the logs and not being very comfortable with BGP I'm not too sure about who's not speaking to who!

Is the ISP dropping connection or are the two 6513's not keeping each other updated?

2 REPLIES
Cisco Employee

Re: BGP Query

Hello,

I assume that R1 and R2 have a BGP peering to each other and that this peering flaps occassionally.

It seems to me that the BGP keepalive messages are somehow not passed properly between your routers. The R1 obviously decides that the R2 has not reported itself for too long so it sends it a notification message to inform it about closing the session. The R2 receives this notification and closes the session, too. After a couple of seconds, both peers create a new connection.

Is there anything special in the BGP configuration of your routers, especially regarding keepalive or holdtime values? Also, is it possible that the load on your routers is excessive? That could theoretically cause the routers to miss the keepalive messages.

Best regards,

Peter

New Member

Re: BGP Query

Thanks for that, I'll check out the keepalives.

123
Views
0
Helpful
2
Replies