Hi, i have an MPLS network using BGP to advertise routes. i also have an IPSEC VPN (via ASA) that i want to be a backup. i have tried configuring OSPF on the core switch and getting the MPLS CPE to redistribute into OSPF but no luck. idea being core switch has learnt routes when MPLS working, MPLS down -> routes removed and default route to ASA takes over.
Cisco 2921 (MPLS)
LAN -> Core Switch
switch is default gateway and has 2 vlans (1 for MPLS and other for LAN/ASA) it has a default route pointing to ASA
what i have configured:
router ospf 10
redistribute bgp 42 subnets
redistribute connected subnets
router bgp 42
neighbor 192.168.229.2 remote-as 69
router ospf 10
network 10.44.0.0 0.0.255.255 area 1
network 172.16.200.0 0.0.0.255 area 0
the MPLS has the BGP routes fine but i cant get the switch to see them, any help much appreciated
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...