Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

binding of access-lists

Hello,

This is regarding SNMP config on 2980G Catos switch for ver 8.4.9

We have issued the following commands on the switch:

1)For SNMP Access list : set snmp access-list access_number IP_address [ipmask maskaddr]

I would like to know where the binding of access-list would be done when we defining for SNMP configuration

Regards,

Arindam

4 REPLIES

Re: binding of access-lists

Arindham,

There is no need to bind the access-list to any interface.

When you configure the above command, then only the stations with IP address in the access-list are allowed to poll.

HTH

Narayan

Community Member

Re: binding of access-lists

Thanks Narayan for yours input

Silver

Re: binding of access-lists

This command automatically binds selected ACL to SNMP server on the switch. Requests can come from any interface.

ACL works for incoming requests only.

Community Member

Re: binding of access-lists

Thanks for yours input.

134
Views
5
Helpful
4
Replies
CreatePlease to create content