Has anyone used a Bit Error Rate Tester (BERT) to generate serial traffic to a router? Ideally I would like to use the BERT to test across the serial link (422)to the router and then over to the 3750 switch and then back again to the BERT! Not sure if this is possible! Can a router be used as a Bit Error Rate Tester on a 422 serial line? Any information would be great.
Bit error rate testers are devices or procedures that measure the bit error rate (BER) for a specific transmission but Router bits are rotating tools that are available in a variety of profiles and shapes. I think router can not used as a Bit Error Rate Tester. If you will do like that the interface will down.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...