Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Bits/sec CATOS

On IOS i get this info:

6500Core2#sho int giga1/1
GigabitEthernet1/1 is up, line protocol is up (connected)
  Hardware is C6k 1000Mb 802.3, address is 0014.f212.21ec (bia 0014.f212.21ec)
  Description: Channel Trunk to Old Core #1
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 9/255, rxload 3/255
5 minute input rate 12102000 bits/sec, 4816 packets/sec
  5 minute output rate 38600000 bits/sec, 5683 packets/sec

How do i get this info on CATOS?


3 REPLIES
Hall of Fame Super Silver

Re: Bits/sec CATOS

Hello Mike,

try to use

sh mac  mod#/port#

it provides a lot of counters

Hope to help

Giuseppe

Community Member

Re: Bits/sec CATOS

This is what i get...

Core6513> (enable) show mac 5/8

Port     Rcv-Unicast          Rcv-Multicast        Rcv-Broadcast
-------- -------------------- -------------------- --------------------
5/8                  8856780                    0                 1936

Port     Xmit-Unicast         Xmit-Multicast       Xmit-Broadcast
-------- -------------------- -------------------- --------------------
5/8                 11797860                23546               166263

Port     Rcv-Octet            Xmit-Octet
-------- -------------------- --------------------
5/8               7092617505           2308297187

MAC      Dely-Exced MTU-Exced  In-Discard Out-Discard
-------- ---------- ---------- ---------- -----------
5/8              0          0          0           0

Port  Last-Time-Cleared
----- --------------------------
5/8  Thu Jan 21 2010, 17:26:25

I am assuming those are packets. I suppose i could time those by the MTU but that wouldn't be entirely acurate. Any other commands?

Purple

Re: Bits/sec CATOS

   There is no 5 minute readouts like IOS  .  If there is a specific port you want to look at you can run a "show top" report against the port  for up to 999 seconds , you can then look at the report .  Actually pretty useful to look at specific ports .   Also show counters slot/port gives you lots of info .  The show top report function explained here.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4000/7.6/command/reference/sh_t_z.html#wpxref18861

155
Views
0
Helpful
3
Replies
CreatePlease to create content