Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Blade switch autoconfiguration, but none set

Hello,

     We have many blade switch C3032 (Dell) in our infrastructure. The fast ethernet interface (management out of band) is configured with a static ip adresse. Today, 80percent of these switch lost the correct configuration to have this configuration commande : ip address dhcp

In syslog, we have only one log :

Jun 15 13:51:55.846 METDST: AUTOINSTALL: FastEthernet0 is assigned 172.16.255.246

But theses switch have'nt restart today M1000-JF4-C3032-1 uptime is 1 year, 41 weeks, 4 days, 1 hour, 0 minutes and the command "show running-config" see no configuration change :

M1000-JF4-C3032-1#  sh run
Building configuration...

Current configuration : 7957 bytes
!
! Last configuration change at 15:15:59 METDST Wed May 19 2010
! NVRAM config last updated at 15:16:03 METDST Wed May 19 2010

The clock time is correctly synchonised with NTP

M1000-JF4-C3032-1#sh clock
.16:15:25.267 METDST Tue Jun 15 2010

Any ideas of the configuration change ????

Why the switch do an autoconfig with fastehternet 0 ?

No one do any configuration on switch today (the switch hav'nt any log of a configuration mode)...

Thanks for help

3 REPLIES
Community Member

Re: Blade switch autoconfiguration, but none set

UP

Community Member

Re: Blade switch autoconfiguration, but none set

Could someone have changed something from the Blade center management module? I know in our organization the server teams are making changes on the management modules all the time.

Just a thought.

Community Member

Re: Blade switch autoconfiguration, but none set

thanks for your respons, but no one do something on the management module... i think wee have to open a ticket to cisco tac...

287
Views
0
Helpful
3
Replies
CreatePlease to create content