I currently have 2 - CIGESMs in a bladecenter. When I run the command show cdp neighbor with the Advanced Mgmt Module installed it shows no neighbors. When I do the same with an older Mgmt Module it works fine. ( I am able to see an upstream switch that is connected to the Cigesm with show cdp neighbor with both the MM and AMM )
Does anyone know if anything needs to be configured differently on the Cigesm to get CDP to work with the AMM ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.