The switch generates %C4K_HWPORTMAN-4-BLOCKEDTXQUEUE:Blocked transmit queue HwTxQId[dec]on[char], count=[dec] errors.
This rate-limited message indicates that a transmit queue on a port is blocked for reasons other than “paused”. In other words, the traffic on that port is being limited and blocked. You see the blocked transmit queue messages if the Supervisor Engine is not able to send packets to the line card because of the reception of a busy bit from the line card. Bad hardware or a speed/duplex mismatch can cause this problem. The workaround is to configure both sides of the link to autonegotiate for speed and duplex. Issue the shut/no shut command in order to recover the port. If the problem persists, move the connected device to another port and see if the problem happens there. As a final measure to unblock the transmit (Tx) queue, issue the hw-module reset command in order to reboot the switch or reset the line card.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.