Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

blocking addresses

Hi all, is there anything I can do to stop certain pcs on my lan seeing servers, the servers are on the same subnet and cannot be changed? any ideas ?

5 REPLIES
Cisco Employee

Re: blocking addresses

New Member

Re: blocking addresses

Is there any other way I can do this ?

cheers

Carl

Cisco Employee

Re: blocking addresses

Carl,

You can use VACLS, vlan ACL's to block the traffic within a single vlan.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3560/12225se/3560scg/swacl.htm#wp1087276

HTH,Please rate if it does.

-amit singh

New Member

Re: blocking addresses

can you show me how I could control access to some servers by using a map, how would i set that up, the servers are on the same subnet as my users, can this still be done, an example would really help?

cheers

New Member

Re: blocking addresses

This is very good, can i do this on my 2950 switch? can you give me a config example of where I want to block traffic in the same vlan to my servers, ie my servers are in the same subnet as my clients, and in the same subnet, I want to block certain pc's on my lan going to the servers. hope someone can help as this will save me buying more equipment.

cheers

140
Views
0
Helpful
5
Replies