Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Blocking CDP duplex mismatch from being logged

Is there any way to block the duplex mismatch errors from CDP from being logged? I have a cisco switch which connects to a non-cisco switch which then connects to a number of devices including a Cisco ATA that does not support full duplex. On the cisco switch the port is autonegotiating to 100/Full, and so is the non-cisco.

When the ATA sends out its CDP packets it tells the cisco switch that it is using 10/half. The cisco switch enterprets that as being an error and logs it as:

%CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/6 (not half duplex), with SEP... Port 1 (half duplex).

It would be handy if I could prevent these from getting logged (or at least rate limit them)

Thanks in advance,

Peter

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Blocking CDP duplex mismatch from being logged

Hi,

Disabling CDP will solve this issue. If you need CDP, but not this messages, try "no cdp advertise-v2".

3 REPLIES
Cisco Employee

Re: Blocking CDP duplex mismatch from being logged

Hi,

Disabling CDP will solve this issue. If you need CDP, but not this messages, try "no cdp advertise-v2".

New Member

Re: Blocking CDP duplex mismatch from being logged

Thanks,

That looks like it should solve the problem. All I lose is the native VLAN detection and VTP management domain - a small price to pay to get rid of the annoying messages in my logs.

Regards,

Peter

Silver

Re: Blocking CDP duplex mismatch from being logged

This breaks Cisco Voice. Any other workarounds?

437
Views
0
Helpful
3
Replies