Can you try with the new image downloading from CCO software download.
Might be your existing image could be corrupted.
Connect the router and PC using a Straight cable.
The following variables are REQUIRED to be set for tftpdnld:
IP_ADDRESS: The IP address for this unit
IP_SUBNET_MASK: The subnet mask for this unit
DEFAULT_GATEWAY: The default gateway for this unit
TFTP_SERVER: The IP address of the server to fetch from
TFTP_FILE: The filename to fetch
Rommon 1 > IP_ADDRESS=10.10.10.1
Rommon 2 > IP_SUBNET_MASK=255.255.255.0
Rommon 3 > DEFAULT_GATEWAY=10.10.10.2
Rommon 4 > TFTP_SERVER=10.10.10.2
Rommon 5 > TFTP_FILE=newimagename .bin
Rommon 6 > tftpdnld
Thank you for your reply i would like to clarify that the used image is working fine because i forced the router to boot with it on the rommon and it's booting properly however it's not the case when i used the command boot system
I also am able to load IOS into RAM and boot directly from rommon without touching flash, but when I execute the "boot system tftp <ios_filename.bin> <tftp server ip address>" or "boot system tftp://<tftp server ip address>/<ios_filename.bin>", copy run star and reload, no luck... goes right back into rommon with error "loadprog: error - on file open boot: cannot load "tftp:c2801-advipservicesk9-mz.124-19.bin 10.0.0.69" Strange.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.